Home Appliance Installation

What We Install

Washing machines, dishwashers, and dryers: we fit a leak-protected aquastop inlet hose, secure the drain into a trapped standpipe or sink siphon at the correct height, connect the appliance to a dedicated socket, remove the transport bolts on washing machines, level the feet so the drum stays balanced at high spin speeds, and run a full test cycle with water before we leave. For condenser dryers we check the water-tank or drain-hose routing, and for vented dryers we verify the exhaust duct runs correctly to the outside.

Refrigerators, freezers, and Side-by-Side units: we let the refrigerant settle after transport before powering on, leave the correct ventilation gap behind and above the unit as specified by the manufacturer, level the feet so the door seats squarely and self-closes, adjust hinges and door-close springs, set initial temperatures, and verify the compartments pull down to target temperature before we leave. For built-in models we fit the decorative door panel and verify the cabinet opening has the airflow path the manufacturer requires.

Electric stoves, cooktops, and ovens: we check that the appliance is on its own dedicated circuit with the correct breaker size and cable cross-section, wire the terminal block as a single-phase (230 V) or three-phase (400 V) connection depending on the model, fit ceramic and induction cooktops into the cut-out with the correct sealing tape, install decorative trim strips on built-in ovens, verify the rear cooling-fan airflow, and run a full function test on every heating zone before we leave.

Re-Connection & Built-In Work

We also handle re-connection jobs after a move, a kitchen renovation, or a countertop replacement – including cases where the existing hoses, terminal block, plinth trim, or cabinet cut-out have been disturbed by other trades. These are small jobs but easy ones to get wrong: an unsecured drain hose, an incorrect phase configuration, or a hob dropped into a cut-out without the correct sealing tape is a classic cause of an avoidable service call a week later.

For fully integrated (built-in) appliances we fit the decorative door panels, adjust the hinges and door-close springs, verify the cabinet opening has correct ventilation, and coordinate with the kitchen fitter so the final finish is uniform. We also install extractor hoods with either a ducted or carbon-filter configuration and make sure the top and side panels sit at the dimensions the manufacturer requires.

For apartment associations, landlords, and companies we offer service contracts covering multiple-appliance installations across a building, with scheduled visits, transparent pricing, and a single invoice per visit. Tenants or staff get the new appliance set up the same day, and the facility manager has a single point of contact for every installation.

What's Included

• Washing machine, dishwasher, and dryer connection with aquastop and test cycle
• Refrigerator and freezer installation with ventilation and door-seating check
• Electric stove, hob, and oven wiring on dedicated 230/400 V circuits
• Built-in appliance fitting, decorative panels, and cabinet adjustment
• Re-connection after moves, kitchen renovations, and countertop changes
• Bosch, Siemens, Electrolux, AEG, Miele, Samsung, LG, and other common brands