Built-in Appliance Installation

What We Integrate

Built-in ovens, steam ovens, microwaves, and warming drawers: we verify the cabinet opening against the manufacturer's installation drawing, especially the rear cooling-fan ventilation path, connect the appliance to its dedicated circuit with the correct cable cross-section and breaker rating, secure the unit to the cabinet side walls with the supplied screws, install the decorative trim strips and plinth panels, and run a full function test on every heating mode and zone before we leave.

Integrated dishwashers: we connect a leak-protected inlet hose, route the drain through a trapped siphon at the correct height, fit the decorative door panel precisely flush with the kitchen cabinetry, adjust the hinge and spring tension so the door opens and closes at the correct angle, trim the top and side panels, and run a full test cycle with water before we leave. For fully integrated (fully hidden) models we also verify the steam-release vent and the top edge of the door panel aligning with the worktop.

Ceramic and induction cooktops, extractor hoods: we fit the cooktop into the worktop cut-out with the correct sealing tape, wire the terminal block as single-phase (230 V) or three-phase (400 V) depending on the model, install the extractor hood either as a ducted system venting outside or with carbon filters in re-circulating mode, route the duct correctly through the kitchen cabinet or ceiling void, and install coffee machines with plumbed water connections where the model requires a separate inlet and drain.

Fully Integrated Refrigerators & Coordination

Fully integrated refrigerators and freezers (full-height integrated columns) require a door-on-door decorative panel installation – meaning when the kitchen cabinet door opens, it pulls the appliance's own door with it. We install and adjust either the sliding-rail or fixed-fitting kit, make sure the cabinet doors and the appliance door close in sync, and tune the door closer so the closing force on both doors is even. We also verify that the cabinet opening provides the airflow path the manufacturer requires, since built-in refrigerators depend on heat being drawn out through the top of the cabinet.

We coordinate with the kitchen fitter before the appliance even arrives: we verify worktop cut-out dimensions, cabinet opening height and depth, socket placement, and water and drain outlet heights. Most built-in installation problems stem from these details being fixed after the cabinetry is already installed – and at that point they are no longer cheap to fix.

We offer a built-in appliance installation package for a whole kitchen: three to eight appliances in one visit, a single invoice, a single point of contact, and every appliance tested before we leave. Suitable for new kitchens, renovations, and appliance replacements for apartment associations and developers. All installations come with a two-year workmanship warranty.

What's Included

• Built-in oven, steam oven, and microwave installation with trim strips and ventilation
• Integrated dishwasher fit-out with decorative door panel and hinge alignment
• Fully integrated refrigerator and freezer column with door-panel coupling
• Ceramic and induction cooktop cut-in with sealing tape and dedicated 230/400 V wiring
• Ducted or re-circulating extractor hood installation with duct routing
• Bosch, Siemens, Miele, AEG, Neff, Gaggenau, and other premium brands